Qualube Hydraulic HM46
is recommended for your ROBBINS
Recommendations for your ROBBINS
All our lubricants are designed to meet all the required standards and requirements of the Original Equipment Manufacturers, as well as ensuring the latest ACEA and API quality recommendations. If you need any help choosing or locating the right oil for your engine or equipment please contact us and we will be happy to help.
Hydraulic System
Recommendation
Product 1
Qualube Hydraulic HM46
Product 2
Qualube Hydrapower HV46
Capacity
2,120 (ltr)
Notes
- a. Typical capacity, individual machines may vary
- b. Analyze oil sample every 500 hours to determine change interval. Drain, clean and refill twice yearly, depending on severity of operating conditions
Grease Fittings
Recommendation
Product 1
Qualube Lithium EP 2
Product 2
Qualube Lithium Complex 2
Cutter assemblies
Recommendation
Capacity
1.0 (ltr)
Notes
- a. Typical capacity, individual machines may vary
- c. Approved oils: Shell Omala 220 or Mobilgear 630. Approved grease: Mobil Temp 78. Otherwise, refer to manufacturer. Oil is replaced at each cutter ring replacement
Exposed steel & adjusting screws
Notes
- d. Alternative recommendations: Qualube Hydraulic HM46 / Qualube Hydrapower HV46
Flushing hydraulic system
Recommendation
Product 1
Qualube Hydraulic HM32
Product 2
Qualube Hydrapower HV32
Notes
- e. As required
Lubrication
Capacity
397 (ltr)
Notes
- a. Typical capacity, individual machines may vary
- b. Analyze oil sample every 500 hours to determine change interval. Drain, clean and refill twice yearly, depending on severity of operating conditions
Reduction Gears
Capacity
18.8 (ltr)
Notes
- a. Typical capacity, individual machines may vary
- b. Analyze oil sample every 500 hours to determine change interval. Drain, clean and refill twice yearly, depending on severity of operating conditions
Snubber pulley assemblies
Capacity
15.0 (ltr)
Notes
- a. Typical capacity, individual machines may vary
- f. Replace at unit rebuild
Tail pulley assembly
Capacity
11.3 (ltr)
Notes
- a. Typical capacity, individual machines may vary
- f. Replace at unit rebuild
Oil Change Intervals
Hydraulic System
Months Max | 6 |
Grease Fittings
Hours Max | 40 |
Lubrication
Months Max | 6 |
Reduction Gears
Months Max | 6 |