Application |
Recommendation |
Capacity (ltr) |
|
|---|---|---|---|
|
Crankcase
|
Contact with our Technical Team (a, b) |
|
|
|
Cylinders
|
(c) |
|
|
| a. | Minimum specification; Viscosity 100°C, 65 to 75 SSU, flash point 227°C min, fire point 250°C min, carbon residue 0.15% max. General recommendation; good quality two cycle gas engine oil with foam and oxidation inhibitors. SAE 40 ashless detergent/dispersant two-cycle gas engine oil preferred. Detergent or other oils may be required under certain circumstances. Consult with manufacturer |
| b. | Precautions are required to prevent excessive pressure drop across filter on start up. Operation of the engine with oil viscosity greater than 2000 SSU (i.e. oil temperature lower than 21°C) is not recommended. Use oil heater and circulatory pump when ambient temperature at installation falls below 21°C |
| c. | Lubricants must be selected on the basis of the process gas and must be compatible and of the appropriate viscosity. Synthetics are specified for certain gases. Refer to manufacturers 'Special Instructions for Compressor Cylinder Lubrication and Break-in', Form PG-631-C |
There are no notes to display for this model
There is no Oil Change Interval data to display for this model
Copyright © OATS Ltd. 2024